Byrd Tool - 6" Shelix Cutterhead
click to zoom
Need it by Tue. Apr 25th?
Just order by 2:00 PM PST on Mon. and choose expedited shipping during checkout.
- Grizzly G1182 series (mfg. since 2003)
- Grizzly G0452 series
- Grizzly G0654
- Bridgewood BW-6R
- General 80-100L
- General 80-150L
- Jet JJ-60S
- Jet JJ-6CSX
- Jet JJ6CSDX
- Powermatic 1791279DX-54A
- Powermatic 1791279DXK-54A
- Ridgid JP0610
- Shop Fox W1679
- Sunhill CT-60L
- Sunhill SM-150
Accessories and Related Items:
You May Also Like:
Customers who purchased this item also purchased:
7 Customer Reviews (5 out of 5 stars): Sign in to write a review
Byrd makes two heads for the Jet 6" CSDX jointer. This 6" cutter is for the older model - if the circumference of your cutter is ~ 7 7/8" this cutter will fit. Grizzly support wasn't aware of the difference...
I bought this for my Ridgid JP06101 jointer. There is a little confusion as the cross reference shows this cutterhead fits a Ridgid JP0601 (there is a one digit difference in the model number) but it works fine as an upgrade on my Ridgid. The shaft length where the drive pulley is installed is slightly shorter in length than the original head that came with my Ridgid jointer, but that wasn't an issue. Shaft diameters where the bearings mount are correct and match the original cutter head. You need a gear puller to remove the bearings from the old cutter head and some way of pressing the bearings on the new Shelix cutterhead. I had a gear puller but had to modify the arms to fit under the bearings so it would work. I just used a deadblow hammer and a deep socket to reinstall the bearings on the new cutterhead. I also wore very heavy leather cloves when handling the cutterheads as the knives/blades are very sharp. I sanded the original drive key so it would fit in the new cutterhead's keyway easier, but still a snug fit. Removal and installation is a little tricky in getting the mounting bolts to line up, but patience is the key. Total time for removal and reinstallation including bearing swapping, probably about two hours. maybe a little longer. Runs quieter, cuts smoothly. I like it. Prior to this I had replaced the cutterhead in my Dewalt 735 planer with a 13" Shelix cutterhead. It too runs quieter and cuts smoothly.
I purchased this for my Jet 6" Jointer planer. It installed easily, the only slight problem was the key slot was slightly smaller than the key that I removed. But a few minutes with a file and a few thousandths of an inch off the key fixed it. While I was replacing the cutterhead I also replaced the bearings and the v-belt as well. After alignment it worked perfectly and produced a very smooth finish. By the way this cutterhead has a 63mm cutting circle as mentioned in other review the circumference of your cutterhead should be about 7 7/8 inches or less. If it is larger, this is not the proper cutterhead.
After 10 years using the same knives on my Powermatic Jointer I made the call to upgrade rather than try and change the blades. This head is very quiet with better cut quality compared to the old blades.
Love it. A bit of work to install but fit perfectly in my powermatic jointer. Way, way better glue line finish than straight knives. No tearout at all. I'll never go back.
Very pleased with this cutter head. Install was fairly simple.\r\nGreat cutting quality. Smooth and no tear outs even on woods like hickory, maple and cherry\r\nShop noice significantly reduced.\r\nWell worth the cost.